YASKAWA yasnac lx3 - Page 178

4, 3, 6.3 Setting Data of Decimal Display Format
(Cent’d)
(2)
a.
b.
c.
d,
Fig. 4.36 Display of Setting Data
inDecimalMode
Writing of setting data (decimal display
format)
The writing of the setting data of decimal
display format
is performed by the following
operations:
Depress the SET function key.
By the operation of PAGE key and CURSOR
key or keying in 4-digit value, designate the
setting number to be written.
Key-in the value by the data key and de-
press the WR key.
The keyed value is
written as the data of the setting number
designated by the cursor.
Repeat operations of b. and c. to write the
necessary setting data.
REMARKS >
System No. setting (#6219)
Set system No. at
II111to write
parameter num-
ber.
System number can be set by setting the
value of #6219 through the operator’s panel.
Setting of #6219
llO1!:
SYSTEM
For normal operation. Writing parameters is pre-
vented.
!ll!l:
PARAMETER
To write parameters.
At this position, Cycle
start is prevented,
“4” : TEST (0)
Normal operation is similar to the case of ‘1O1!
SYSTEM. Self-diagnostics of the memory contents
and checking of reference zero return point are
omitted,
Notes :
1.
Setting values other than those described
above will prevent correct operation.
2. Setting can be effective only when the system
number switch provided on the upper part of
the unit is set at “O.“
Alarm Display of System No. Setting (#6219)
When setting #6219 is set at ‘11“or “4,“ Cycle
Start is prohibited or self-diagnostics are over
looked, causing unexpected
errors.
To prevent this,
alarm status is displayed if
#6219 is set at a value other than “O. “
v;
SYSTEM NO. SETTING (#6219):[11
I
MESSAGE
I
I
System number #6219 should be set at “O” except
for writing parameters,
. System number can also be set by the rotary
switch on the main printed circuit board.
For
details, refer to Maintenance Manual.
4.3.7
DISPLAYING AND WRITING PARAMETERS
In this system, varying parameters are stored in
the memory and they determine operating condi-
tions such as tape code and feedrate. For de-
tails,see Appendix 2,
“LIST OF PARAMETER
NUMBERS .“ The parameters may be displayed at
any time even during automatic operation.
The parameters are of the following two types:
(1) The parameters of bit display format.
(2) The parameters of decimal display format.
170