YASKAWA yasnac lx3 - Page 192

4. 7.1 OUTPUTTING A PART PROGRAM TO PAPER
“TAPE (Cent’d)
j~~te :
The contents of program number 00000
are outputted only when #6231D 3 = 1.
47, 2
OUTPUTTING TOOL OFFSETS TO PAPER TAPE
Tool offsets may be output to paper tape by the
following operations:
( 1)
(2)
{ 3)
(4)
( 5)
(6)
(7)
(8)
(9)
Connect the external equipment such as the
tape puncher to the NC via the data input/
output interface.
Make the external equipment ready for
operation.
Power on the NC.
Select the EDIT mode.
~Jepress the OF S function key.
Check to see if the external equipment is
ready.
Depress the RESET key.
Depress the OUT key.
All contents of the offset memory such as
tool offsets and tool coordinate data are out-
putted to the external equipment. If the
external equipment is a tape puncher, tape
punch out is performed. When the output
of the data is completed, the external equip-
ment stops automatically.
To discontinue the punch out operation,
depress the RESET key. However, the dis-
continued operation cannot be resued. Go
back to (6) and repeat the operations all
over again.
The format of the punched out
tape is the same as that of the tape described
4.7.3
OUTPUTTING SETTING/PARAMETER DATA TO
PAPER TAPE
Setting/parameter data
may be punched out by
the following operations.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Connect the external equipment such as the
tape puncher to the NC via the data inputl
output interface.
Make the external equipment ready for
operation.
Power on the NC .
Select the EDIT mode.
Depress the PRM function key if the output
of both setting data and parameter is de–
sired.
If the output of only setting data is
desired, depress the SET function key.
Check to see if the external equipment is
ready.
Depress the RESET key.
Depress the OUT key .
All setting data and parameters are output
to the external equipment, If it is a tape
puncher, tape punch out operation is per-
formed. When the output oi the data is
completed, the external equipment stops
automatically.
in-4.4.4, (l).
184