2.8.7 CORNERING (G 11, G @ ‘
(1) Beveling (Gil)
{
X( U)... K.. .
Gll
1
F(E) . . . ;
Z(W) . . . 1.. .
This command removes the sharp corner of
workpiece.
Addresses X and Z cannot be
specified simultaneously in a block.
Meaning of each address is shown below.
Table 2.13
Beveling for X-axis
Gll X( U)... K.., F(E)... ;
END
+X
I
POINT
K- K+
m
N
45”
Ux
2
(DIAMEI
START POINT
“ER)
K *
[
L
Bevellng Value
~ Bevellng Dlrecllon
Beveling for Z-axis
I+
I–
Gll Z(W)... 1... F(E)... ;
END POINT
@7
,,50
START
/
w
POINT
I f
JZ
—
Bevellng Value (Raalus Value)
L-
Beve, ing Dlrectlon
Beveling values (K and I) are limited within
the following values.
(2) Rounding (G12)
The command exceeding the above value causes
format error.
This command performs the rounding of the
corner.
Addresses X and Z cannot be spec -
GOO X30. ZO ;
ified simultaneously in a block. The corner
is formed
ZLS a quarter–round.
Meaning of
~
Gll Z-20. 18. F30 ;
each address is shown below.
@ I (Gil) x80. K-7. ; I
I
I
7, 20.
+x
B
O
DIA ‘~
8.
lo
30 DIA
-z
Fig. 2.10
31
To Next Page
Loading...
