To Next PageTo Next Page
What to do if my YASKAWA Z1000 Controller displays External Fault (input terminal S1 to S7)?
If there is an external fault at multi-function input terminal S1 to S7, reset the YASKAWA Controller drive by pushing the Reset key on the keypad or cycle the power supply.
What to do if YASKAWA Z1000 shows MEMOBUS/Modbus Communication Error?
If control data was not received for the CE detection time set to H5-09, reset the YASKAWA Controller drive by pushing the Reset key on the keypad or cycle the power supply.
How to resolve EEPROM Memory Data Error on YASKAWA Z1000?
If there is an error in the data saved to EEPROM, reset the YASKAWA Controller drive by pushing the Reset key on the keypad or cycle the power supply.
General| Model | Z1000 |
|---|---|
| Category | Controller |
| Humidity | 95% RH or less (non-condensing) |
| Control Method | V/F Control |
| Frequency Range | 400 Hz |
| Protection | Overcurrent, Overvoltage, Undervoltage, Overheat |
| Communication Options | Modbus |
| Operating Temperature | -10 to 50°C |
| Storage Temperature | -20 to 60°C |
| Altitude | Up to 1000 meters without derating |
| Cooling Method | Forced Air |
| Enclosure Rating | IP20 |
| Voltage Class | 200V, 400V |
