Yealink MP50 - Advanced Audio and Reset Settings; Noise Control and Shielding; Factory Settings Restoration; Restoring Factory Defaults

Noise
Suppressio
n
If enabled, it will suppress the background noise of the sender and improve the signal-to- ratio.
Smart Noise
Block
Enable/disable the base to block out/eliminate the noises when in a call.
When you make a call via speaker mode, enable this function can block out/eliminate the noises
when there is no speech in a call.
Acoustic
Shield
Mode
Set the noise suppression feature of the headset and handset.
Acoustic
Shield Level
Set the noise suppression level of the headset and handset.
FAQFAQ
Restore Factory SettingsRestore Factory Settings
Restore Factory SettingsRestore Factory Settings
The following takes MP50 as an example.
1. Open the Yealink USB Connect software and select the desired device CARD.
2. Go to Device settingsDevice settings > Device supportDevice support.
3. Select Restore Factory SettingsRestore Factory Settings.
 TIPTIP
If you encounter a problem or can not complete an action, use Troubleshooting to identify and resolve the
problem.
Yealink MP50
User Guide
GoMomentum.com/support | 888.538.3960
23