Yealink IP Phones Configuring Guide
56
Configuration Files on page 7.
Intercom is a useful feature in an office environment to quickly connect with the operator
or the secretary. You can short press the Intercom/PTT key to automatically connect with
a preconfigured target extension for outgoing intercom calls, and the target extension
will automatically answer incoming intercom calls by default.
Push-to-talk is a variant of Intercom, you need to press and hold the Intercom/PTT key
during the push-to-talk call. As soon as the key is released, the push-to-talk call is
disconnected.
Note
You can press an Intercom/PTT key to automatically initiate an outgoing intercom call
with a remote extension.
Push to Talk Mode Enable
You can enable or disable the push-to-talk mode for the phone. If push-to-talk mode is
enabled, you can long press the Intercom/PTT key for 1.5 seconds to automatically
connect with a preconfigured target extension, and the target extension will
automatically answer incoming intercom calls by default. You need to press and hold
the Intercom/PTT key during the push-to-talk call and release it to end the call.
If push-to-talk mode is disabled, the Intercom/PTT key can work as an Intercom key only.
To configure push-to-talk mode via CommPortal phone configurator:
1. Click on Features-> Intercom.
Mark the desired radio box in the Push to Talk Mode Enable field.
2. Click Save changes to accept the change.
3. Perform auto provisioning on the phone to download above configurations. For
To Next Page
Loading...
Need help?
General
Weight and Dimensions
