EasyManuals Logo

Yealink SIP-T41P Configuration Guide

Yealink SIP-T41P
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
Using Your Phone
59
5. Mark the desired radio box in the Intercom Barge field.
6. Click Save changes to accept the change.
7. Perform auto provisioning on the phone to download above configurations. For
more information on how to perform auto provisioning, refer to Downloading
Configuration Files on page 7.
To place an intercom call when push-to-talk mode is disabled:
1. Short press the Intercom/PTT key when the phone is idle.
The called destination plays a warning tone and automatically answers the call in
the speakerphone mode by default.
2. To end the intercom call, press the Intercom/PTT key again or the EndCall soft key.
To place a push-to-talk call when push-to-talk mode is enabled:
1. Long press the Intercom/PTT key for 1.5 seconds when the phone is idle.
The called destination plays a warning tone and automatically answers the call in
the speakerphone mode by default.
2. Keep pressing the Intercom/PTT key during the push-to-talk call.
3. To end the push-to-talk call, release the Intercom/PTT key.
You can use multicast paging to quickly and easily broadcast time sensitive
announcements to users who are listening to a specific multicast group. You can
configure a multicast paging key or the paging list key on the phone, which allows you
to send a Real Time Transport Protocol (RTP) stream to the pre-configured multicast
address(es) without involving SIP signaling. You can configure the phone to receive an
RTP stream from pre-configured multicast listening address(es) without involving SIP
signaling. You can specify up to 10 multicast listening addresses.

Other manuals for Yealink SIP-T41P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T41P and is the answer not in the manual?

Yealink SIP-T41P Specifications

General IconGeneral
Power requirementsAC 100-240V, DC 5V
Power over Ethernet (PoE)Yes
Touchscreen-
Display diagonal2.7 \
Display resolution192 x 64 pixels
Lines quantity- lines
Phonebook capacity1000 entries
Number of VoIP accounts3
Voice codecsG.711, G.723, G.726, G.729A, G.729B
BluetoothNo
Ethernet LAN (RJ-45) ports2
Storage temperature (T-T)-10 - 50 °C
Operating relative humidity (H-H)10 - 95 %
MountingDesk/Wall
Handset typeWired handset
Product typeIP Phone
Product colorBlack
Number of handles included1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth189 mm
Width212 mm
Height175 mm

Related product manuals