Basic Call Features
69
z Using the speakerphone
z Using the headset
You can also dial the number first, and then choose the way you want to speak to the
other party.
You can search the call history, the local contact directory or the remote phonebook
and dial from the search results. For more information, refer to Contact Management
on page 35 and Call History Management on page 45.
During a call, you can alternate between Speakerphone, Headset, or Handset modes
by pressing the Speakerphone key, the HEADSET key, or picking up the handset.
The call duration of active calls is visible on the LCD screen. In the figure below, the call
to the number ”1000” has lasted 4 seconds.
To place a call using the handset:
1. Pick up the handset.
2. Enter the desired number using the keypad.
3. Press , , or the Send soft key.
By default, the # key is set to be a send key. You can set the * key as send key or set
neither of them to be send keys. For more information, refer to the Key as Send on page
30.
Note
To place a call using the hands-free speakerphone mode:
Do one of the following:
- With the handset on-hook, press or the line key to obtain a dial tone.
Enter the desired number using the keypad.
Press , or the Send soft key.
You can also dial using the SIP URI or IP address. To obtain the IP address of your phone,
press the OK key. The maximum SIP URI or IP address length is 32 characters. For
example, 192.168.1.15, SIP URI: 3606@sip.com.
Your phone may not support direct IP dialing. Contact your system administrator for
more information.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
