Yealink SIP-T54W

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
361
takes precedence over that configured by this parameter.
Permitted
Values
0-prevent users from entering a number and immediately dial out the entered numbers
1-the dialing will fail and the phone screen will prompt “Forbidden Number”
2-allow users to accumulate digits and dispatch call manually with the send key or automatically dial
out the entered number after a certain period of time configured by the parameter “dial-
plan.digitmap.interdigit_long_timer”
Default
0
Parameter
dialplan.digitmap.active.on_hook_dialing <y0000000000xx>.cfg
Description
It enables or disables the entered numbers to match the predefined string of the digit map in real time.
It is only applicable to the on-hook dialing.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.active.on_hook_dial-
ing” takes precedence over that configured by this parameter.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
dialplan.digitmap.apply_to.on_hook_dial <y0000000000xx>.cfg
Description
It enables or disables the entered number to match the predefined string of the digit map after press-
ing a send key when dialing on-hook or pressing the DSS key (for example, speed dial, BLF or prefix
key).
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.apply_to.on_hook_
dial” takes precedence over that configured by this parameter.
Permitted
Values
0-Disabled
1-Enabled
Default
1
Parameter
dialplan.digitmap.apply_to.directory_dial <y0000000000xx>.cfg
Description
It enables or disables the digit map to be applied to the numbers dialed from the directory.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.apply_to.directory_
dial” takes precedence over that configured by this parameter.
Permitted
Values
0-Disabled
1-Enabled
Default
1
Parameter
dialplan.digitmap.apply_to.history_dial <y0000000000xx>.cfg
Description
It enables or disables the digit map to be applied to the numbers (received calls or missed calls)
dialed from the call history list.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.apply_to.history_dial”
takes precedence over that configured by this parameter.
Permitted
Values
0-Disabled
1-Enabled
Default
0