Yealink T27P - Page 473

Configuring Advanced Features
459
framework. TR-069 uses common transport mechanisms (HTTP and HTTPS) for
communication between CPE and ACS (Auto Configuration Servers). The HTTP(S)
messages contain XML-RPC methods defined in the standard for configuration and
management of the CPE.
TR-069 is intended to support a variety of functionalities to manage a collection of CPEs,
including the following primary capabilities:
 Auto-configuration and dynamic service provisioning
 Software or firmware image management
 Status and performance monitoring
 Diagnostics
The following table provides a description of RPC methods supported by IP phones.
RPC Method
Description
GetRPCMethods
This method is used to discover the set of methods
supported by the CPE.
SetParameterValues
This method is used to modify the value of one or
more CPE parameters.
GetParameterValues
This method is used to obtain the value of one or
more CPE parameters.
GetParameterNames
This method is used to discover the parameters
accessible on a particular CPE.
GetParameterAttributes
This method is used to read the attributes associated
with one or more CPE parameters.
SetParameterAttributes
This method is used to modify attributes associated
with one or more CPE parameters.
Reboot
This method causes the CPE to reboot.
Download
This method is used to cause the CPE to download a
specified file from the designated location.
File types supported by IP phones are:
 Firmware Image
 Configuration File
Upload
This method is used to cause the CPE to upload a
specified file to the designated location.
File types supported by IP phones are:
 Configuration File
 Log File
ScheduleInform
This method is used to request the CPE to schedule a
one-time Inform method call (separate from its