Yealink W52H - About This Guide; Introduction to the User Guide; Getting Started; Product Overview

Handset Registration
The handset in the W52P package is pre-registered to the base station. Internal handset number and name display on
the idle screen after turning the handset on. If your handset is not pre-registered to the base station, do one of the
followings to register it manually:
 If the handset LCD screen prompts “Searching for Base”, long press on the base station till the registration LED flashes.
Then press the OK key to enter the main menu, and then select Settings->Registration->Register Handset to register the
handset.
 If the handset LCD screen prompts “Press base page 2s then press OK”, long press on the base station till the
registration LED flashes. Then press the OK soft key on the handset.
Shortcuts
This helps you get quick access to features by pressing the shortcut keys directly without having to scroll through the
menu.You can press the following predefined shortcuts to access some frequently used features of your handset when
the handset is idle:
 Press to access the call history.
 Press to check the line status.
 Press to place an internal call.
 Press to access the directory.
 Press to decrease the ringer volume.
 Press to increase the ringer volume.
Getting Started
Getting Started
Network Settings
You can configure the base station to obtain network settings in one of the following ways:
DHCP: By default, the base station attempts to contact a DHCP server in your network to obtain the valid network
settings, e.g., IP address, subnet mask, gateway addres and DNS address.
Static: If the base station cannot contact a DHCP server for any reason, you need to configure the IP address,
subnet mask, gateway address, primary DNS address and secondary DNS address for the base station
manually.
PPPoE: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE mode. Contact the
ITSP for the account and password.
To configure the network parameters for the base station manually:
1. Press the OK key to enter the main menu, and then select Settings->System Settings -> Network.
2. Enter the system PIN (default: 0000), and then press the Done soft key.
3. Select desired type from the IP Address Type field.
4. Make the desired changes.
5. Press the Save soft key to accept the change.
Note: The wrong network settings may result in inaccessibility of your phone and may have an impact on the network Performance.
For more information on these parameters, contact your systme administrator.
ENGLISH
3