DECT IP Phone – W60B & W56H
GETTING STARTED
SHORTCUTS
Shortcut keys help you quickly access to frequently used phone features. Check the
default shortcut keys below:
ENTERING AND EDITING DATA
• Press one or more times to switch among input modes or enter “#”.
• Press to select the special characters or enter “*”.
• Press a digit key one or more times to enter the desired character or digit.
• Press the Del soft key to delete entered characters.
• Press the Save soft key to accept the change or to cancel.
Note:
• The W60B must work with the W56H handset running the firmware version 61.81.0.30 or later. We
recommend you first upgrade the older handset before using on the W60B. When you upgrade the
older handset via W60B, the number of the handsets registered on the W60B should be no more
than 5. If it is more than 5, deregister the newer handset first and then upgrade the remaining handsets.
Repeat the step to upgrade all the older handsets. Once all handsets are on the right version, you can
register up to 8 handsets on the W60B.
HANDSET REGISTRATION
You can register up to 8 handsets to one W60B base station. Each handset can be registered to 4 different
base stations. When the handset LCD screen prompts “Unregistered!”, long press on the base station till
the registration LED flashes. There are two methods to register a new handset:
Easy Registration:
1. Press the Reg soft key on the handset to register quickly.
Normal Registration:
1. Press the OK soft key on the handset, and then select Register Handset.
2. Select the desired base station and then press the OK soft key. The handset begins searching the
base station.
3. Press the OK soft key after searching a base station successfully.
4. Enter the base station PIN (default: 0000), and then press the Done soft key to complete registration.
To register to multiple base stations, press the OK to enter the main menu, and select
Settings->Registration->Register Handset, then repeat steps 2-4.
Note:
• If the handset is registered to the base station successfully, the handset LCD screen prompts “Handset
Subscribed” and “Base NO.” (last 4 characters indicate the base station’s MAC address).
•
If the handset LCD screen prompts “Searching for Base”, check if your base station is powered on or not.
To Next Page
Loading...
Need help?
General
