NeoGate TE100 Administrator Guide
www.yeastar.com Page 13
·DHCP
If your ISP says that you are connecting through DHCP or a dynamic IP address from
your ISP, perform these steps:
Step1: Select DHCP as the WAN Connection Type.
Step2: Click Save button to save the settings.
Step3: Reboot the device.
Step4: Check the WAN‟s Status (Status Network Status).
·Static IP Address
If your ISP says that you are connecting through a static or fixed IP address from your
ISP, perform these steps:
Step1: Select Static IP Address as the WAN Connection Type.
Step2: Enter the IP Address.
Step3: Enter the Subnet Mask.
Step4: Enter the Gateway Address.
Step5: Enter the Primary DNS and Secondary DNS.
Step6: Click the Save button to save the settings.
Step7: Reboot the device.
Step8: Check the WAN‟s Status (Status Network Status).
·PPPoE
If your DSL provider says that you are connecting through PPPoE or if you
Normally enter a user name and password to access the Internet, perform these
Steps:
Step1: Select PPPoE as the WAN Connection Type.
Step2: Enter the User Name.
Step3: Enter the Password.
Step4: Click the Save button to save the settings.
Step5: Reboot the device.
Step6: Check the WAN‟s Status (Status Network Status)
5.1.3 DDNS settings
DDNS(Dynamic DNS) is a method / protocol / network service that provides the
capability for a networked device, such as a router or computer system using the
Internet Protocol Suite, to notify a Domain Name System (DNS) name server to change,
in real time, the active DNS configuration of its configured hostnames, addresses or
other information.
To Next Page
Loading...