NeoGate TE100 Administrator Guide
www.yeastar.com Page 16
·Drop All
When you enable „Drop All‟ feature, system will drop all packets or connection from other
hosts if there are no other rules defined. To avoid locking the devices, at least one „TCP‟
accept common rule must be created for port used for SSH access, port used for HTTP
access and port used for CGI access.
2) Common Rules
There are no default rules inside; you can create them as required
Figure 5-6
·Name
A name for this rule, e.g. „HTTP‟.
·Description
Simple description for this rule. E.g.: Accept the specific host to access the web interface
for configuration.
·Protocol
The protocols for this rule.
·Port
Initial port should be on the left and end port should be on the right.
The end port must be equal to or greater than start port.
·IP
The IP address for this rule. The format of IP address is: IP/mask
Ex:192.168.5.100/255.255.255.255forIP 192.168.5.100
Ex:216.207.245.47/255.255.255.255 for IP 216.207.245.47
Ex:192.168.5.0/255.255.255.0 for IP from 192.168.5.0 to 192.168.5.255 .
To Next Page
Loading...
Need help?
General
