4-29
IM DL350E-17EN
Commands
4
Command Function page
:ZOOM:WLAYout (Window Layout)
Sets or queries the window layout that is used when waveforms are zoomed. 4-174
:ZOOM:Z2Target
Sets or queries the source window of Zoom2 when both Zoom1 and Zoom2
are displayed.
4-174
Common Command Group
*CAL?
Executes calibration and queries the result. 4-175
*CLS
Clears the standard event register, extended event register, and error queue. 4-175
*ESE
Sets or queries the standard event enable register. 4-175
*ESR?
Queries and clears the standard event register. 4-175
*IDN?
Queries the instrument model. 4-175
*OPC
Sets bit 0 (the OPC bit) of the standard event register to 1 upon the
completion of the specified overlap command.
4-175
*OPC?
Returns ASCII code 1 when the specified overlap command is completed. 4-175
*OPT?
Queries the installed options. 4-176
*RST
Initializes settings. 4-176
*SRE
Sets or queries the service request enable register value. 4-176
*STB?
Queries the Status Byte Register value. 4-176
*TST?
Executes a self-test and queries the result. The self-test consists of tests of
each kind of internal memory.
4-176
*WAI
Holds the execution of the subsequent command until the specified overlap
command is completed.
4-176
4.1 List of Commands
To Next Page
Loading...
