IM 01C25T02-01E
10-3
10. GENERAL SPECIFICATIONS
< Factory Setting >
T1004.EPS
Static pressur display range
‘0 to 25 MPa’ for M and H capsule and ‘0 to 16 MPa’ for L
capsule, absolute value. Measuring high pressure side.
Tag Number (Tag plate) As specified in order
Software Tag (PD_TAG)
‘PT2001’ unless otherwise both Tag Number and
Software Tag specified in order
Node Address ‘0xF5’ unless otherwise specified in order
Operation Functional Class ‘BASIC’ or as specified
Output Mode (L_TYPE)
‘Direct’ unless otherwise specified in order
Calibration Range (XD_SCALE) Lower/Higher
Range Value
As specified in order
Calibration Range Unit
Selected from mmH
2
O, mmH
2
O(68°F), mmHg, Pa, hPa,
kPa, MPa, mbar, bar, gf/cm
2
, kgf/cm
2
, inH
2
O,
inH
2
O(68°F), inHg, ftH
2
O, ftH
2
O(68°F) or psi.
(Only one unit can be specified)
Output Scale (OUT_SCALE) Lower/Higher
Range Value
‘0 to 100%’ unless otherwise specified.
Software Damping
*2
‘2 seconds’ or as specified in order
Primary value
*1
*1: Primary means differential pressure in case of differential pressure transmitters and pressure in case of pressure transmitters.
*2: To specify this item, /CC option is required.
To Next Page
Loading...
