YOKOGAWA ProSafe-RS User Manual

i
TI 32P01J10-01E
Revision Information
● Title : ProSafe-RS Installation Guidance
● Manual No. : TI 32P01J10-01EN
Mar. 2019/9th Edition
1.2 Measurement Categories [Updated the description of safety standard.]
Conformity Standards [Updated the description of safety standard.]
1.5.1 Examples of Spark-killer and Diode Installation [Added note *2.]
1.8 Compliance with Marine Standards [Added ENV3 to LR.]
Table Marine Standard-compliant ProSafe-RS Components (1/3) [Added the description of S2BN1D.]
Precaution on Installing Components [Add explanation.]
Figure Wiring for power cables [Updated the gure.]
Figure Locations of Ferrite Core Installation for Input/Output Modules, Terminal Boards and Relay
Boards [Added note *2.]
When Leaving a Large Space between Unit Components [Added the specification of EMI shielding
gasket.]
2.5.6 Installation Guideline for Rittal cabinet for N-IO [Updated the specication for cabinet.]
Jan. 2019/8th Edition
1.2 Control Room Environment
■ Conformity Standards
● Application Standards [Notes on surge immunity are changed]
● EMC Conformity Standards [Notes on surge immunity are changed]
1.5.2 Countermeasures against Static Electricity [Arrangement Information of wrist straps and conductive
sheets are deleted]
1.7 Corrosive-gas Environment Compatibility
■ Outline of G3 Environment Compatibility [Contact information for environmental diagnosis is deleted]
2.2 Unpacking
IMPORTANT [Contact information for Condensation is deleted]
Oct. 2018/7th Edition
Front page ProSafe-RS Logo change
Safety Precautions Revision of logo mark description
1.2 Control Room Environment [Add note]
1.7 Table G3 Environment-compatible Products[Add A2BM4]
2.5.3 DIN Rail Mountable Devices [Add A2BM4 and S1XEU4D]
2.5.4 Wall Mountable Devices [Add A2BM4]
2.5.6 Figure Example of Mounting an SCU for N-IO and N-IO Nodes in a Cabinet is revised
Example of Mounting an SCU for N-IO and N-IO Nodes in a Cabinet (In case of field wiring via
terminal board) is added
Example of Mounting N-IO Nodes (Non-Intrinsic Safety Barrier) in a Cabinet (In case of eld wiring via
terminal board) is added
3.1 Cables and Terminals [Add A2BM4]
3.4 Power and Ground Cabling [Add S2BN1D and A2BM4]
3.5 Connecting Signal Cable [Add description for eld wiring]
[Add A2BM4]
3.7.2 Base Plate [Add S2BN1D-□9□□□ and note]
[Add gure of A2BM4]
3.7.3 Base Plate for Barrier [Clerical error correction]
4. Installation Specications [Clerical error correction]]
Mar. 2018/6th Edition
1.2 Control Room Environment ["ground" is change to "grounding"]
1.3 Notes for the eld power supply unit of N-IO is added.
1.5.1 Eamples of Spark-killer and Diode Installation [Title is changed]
1.8 S2LP131 is added.
2.5.3 Figure Mounting stopper to the DIN rail is revised.
2.5.6 Example of Mounting an SCU for N-IO and N-IO Nodes in a Cabinet
Mar. 29, 2019-00

YOKOGAWA ProSafe-RS Specifications

General

Brand	YOKOGAWA
Model	ProSafe-RS
Category	Industrial Equipment
Language	English