Yongnuo YN-E3-RT - MULTI: Stroboscopic Flash Setup; 1. Set Flash Mode to MULTI; 2. Set Firing Groups and Flash Output; 3. Set Flash Frequency and Number of Flashes

MULTI: Stroboscopic Flash
In stroboscopic flash, set the flash output, number of
flashes, and flash frequency (number of flashes per second
= Hz).
1 . S e t t h e f l a s h m o d e t o
<MULTI>.
Press the <MODE> button on
the
master unit and set to <MULTI>.
2.Set the firing groups and the
flash output.
Set the number of firing groups
and the flash output for each
group by referring to the manual
flash on the preceding page.
3.Set the flash frequency and
thenumber of flashes.
While < > is displayed,
perform the following procedure.
To set the number of flashes,
press function button 2 < >,
turn < > and select < >.
To set the flash frequency, press
function button 3 < >, turn
< > and select < >.
17