Need help?Do you have a question about the Yongnuo YN-E3-RT and is the answer not in the manual?
General| Brand | Yongnuo |
|---|---|
| Model | YN-E3-RT |
| Category | Transmitter |
| Language | English |
Setting slave units for ETTL shooting, noting limitations for D/E groups.
Ensuring identical channel and ID for master and slave units.
Setting the master unit to ETTL mode for automatic flash control.
How to adjust flash exposure compensation in 1/3-stop increments.
How to set up flash exposure bracketing levels.
How to enable and use the high-speed sync function.
Assigning slave units to firing groups (A, B, C).
Accessing the menu to set flash ratios.
Selecting the ratio configuration for groups.
Adjusting the flash ratio or exposure compensation.
Taking the picture with the set flash ratios.
Setting the transmitter to Manual flash mode.
Selecting the groups to fire (ALL, A/B, A/B/C).
Choosing a specific group to set its flash output.
Adjusting the manual flash output level.
Taking the picture with manual flash settings.
Setting the transmitter to Multi flash mode.
Setting groups and output for stroboscopic flashes.
Adjusting flash frequency (Hz) and number of flashes.
Setting the transmitter to Group mode.
Assigning slave units to groups (A/B/C/D/E).
Setting the flash mode (ETTL, M, Ext.A) for each selected group.
Adjusting output/compensation based on the group's flash mode.
Navigating camera menu to the external flash control.
Accessing the flash function settings screen.
Customizing specific flash functions via the camera menu.
Accessing the Custom Function settings menu.
Troubleshooting steps for when the device fails to power on.
Troubleshooting steps when slave units fail to flash.
Solutions for firmware update failures or persistent upgrade screens.
How to handle the 'ERROR: 2001' message.
Solutions for incorrect exposure levels in photos.
To Next Page
