Wireless Settings
1.Display < >.
Press function button 4 to
displaym < >.
2.Set a channel.
Press function button 1 <CH>.
Turn < > to select “AUTO”
or a channel from Ch. 1 to 15, and
press the < > button.
3.Set a wireless radio ID.
Press function button 2 < >.
Tu r n < > t o s e l e c t t h e
position(digit) or number to set,
and press the < > button.
Press function button 4 < > to
return to the shooting-ready state.
ØWhen transmission between the
master unit and slave unit is
established, the <LINK> lamp is lit
in green.(Refer to page 26)
To avoid interference, Set the same channel and ID
for both the master unit and slave unit.
Set a flash that is compatible with radio transmission
wireless flash shooting as the slave unit. For the slave
unit settings, see the flash’s instruction manual.
ID
8
Setting the Master Unit Transmission Channel /
Wireless Radio ID.
To Next Page
Loading...
