Yongnuo YN560 - Page 6

13
.
Output
level
indicator
:
Set
the output power by button; there are 8
level
s for
output level adjustment. Indicates the output power and the fine-tuning; it also
indicates
the current focal length when adjusting the zoom.
14. The sound switch: A short press will enable or disable the ready sound; hold
down
the button for longer to turn on/off the power saving mode.
15. Mode switch button: Change the mode of the flash light
; it will cycle through
M/S1/S2 for each press.
16. Charging indicator / Test button: The red light will glow when the
charging
process is complete and the flash light can be used; it will glow green to show
that it is
charging or the batteries are low on power
; alternate flashing of red and green light
shows overheat protection cutout. If you press the test button (PILOT), the flash
will
give a test flash.
17. Power Save indicator: When power saving mode is disabled,
the indicator is lit for
a long period; when the power saving mode is enabled, the light is off. When the
flash
enters sleep mode, the indicator will flash.
18．Flash head manual motor zoom: You can adjust the zoom setting by pressing the
[＋] and [－] keys (24, 28, 35, 50, 70, 80, 105mm).