Yongnuo YN560 - Basic Functions Operation; Basic Operations Overview

V
. Basic Functions
1. Basic Operations
Operation of the buttons:
Component Operation
[Power Switch] Power switch for the flash light. The flash light
can be switched
on/off by pressing this button for 2 seconds.
It is recommended that the batteries be removed from the
battery bay only after the flash light is switched off using this
button.
[Mode Switch
Button]
The trigger mode of the flash light can be cycled through
M/S1/S2 by pressing.
[Sound Switch] Pressing can enable or disable the ready sound signal. Holding
this button down for 2 seconds will enable or disable the
power
saving mode.
[LEFT] and [RIGHT]
button
The output power of the flash light can be adjusted in major
steps through these buttons.