-51-
modes Sc/Sn/S1/S2 for choose),choose a trigger mode,then press [OK] button to save the setting.
For the four off-camera modes of YN565EX II, Sc / Sn is equipped with 3
groups (A, B, and C) respectively and four communication channels (1,2,
through short pressing the [LEFT] and [RIGHT] button.
When the YN565EX II set to Sc/Sn mode, the flash mode,flash light ratio,
the master unit. That is to say, you can just set the related parameters on
the master unit.
3.Multi-flash, Wireless flash Configuration
meet your requirements.
(1) Wireless flash of two slave units made up by YN565EX II.
Wireless option setting: Sc/Sn for operation.
Communication Channel setting: 1, 2, 3, 4.
Master unit setting: Set the communication channel; Set the flash ration of master unit A：B or A：B: C.
You can conduct flash shooting.
into wireless slave unit state. Through the [LEFT] and [RIGHT] buttons to set the slave unit SLAVE (four off-camera
3,4).When the YN565EX II as the slave unit, in Sc/Sn mode, through short
press the [ZOOM] button to choose the focal length,channel,grouping
option.The selected option will blink,then you can set the relevant parameters
exposure compensation,exposure bracketing,flash lock,manual flash output,
stroboscopic flash and other parameters setting will be totally controlled by
You can create two or three slave groups to make better shooting effect to
Groups setting: Set one YN565EX II as group A, and set the other one
as group B.
To Next Page
Loading...
Need help?
General
