-52-
GRP=A
GRP=A
GRP=A
(2) Wireless flash with three slave unit made up by YN565EXII.
Wireless option setting: Sc/Sn.
Channel setting: 1, 2, 3, 4.
Groups setting: Set three YN565EX II speedlites as group A,
group B and group C respectively.
Setting master and shooting: Setting communication channel;
The master control unit of the flash ratio as <A: B C>.
Press the test button of master unit to test whether the flash works
Note: If the master unit set to <A: B> is set, then set the slave unit in group C will not fire.
speedlite in slave group A.
4.Shooting Examples with Wireless Flash System
of Nikon’s, SU-800 and ST-E2.
at most.
Use the mini flash stand (tripod socket provided) to prop up the salve unit YN565EX II.
Rotate the slave unit YN565EX II to make its wireless sensor faces the master unit.
After positioning the YN565EX II, be sure to test the wireless flash operation before shooting.
normally or not; if the slave unit does not fire, adjust the angle of the
YN565EX II toward the master unit and distance from the master unit.
If you have set the three YN565EX II to slave group <A>, all the three slave units will be controlled by one
Master unit: YN568EX II, 600EX-RT,580-II, SB-900/800/700, 7D/60D/600D with built-in flash, C-commander
Slave unit: YONGNUO EX series flash with slave unit flash function,which can be created three slave groups
Indoors, the wireless signal can also be bounce off the wall so there is more leeway in positioning the slave unit(s).
Do not place any obstacles between the master unit and slave unit(s). Obstacles can block the transmission
of wireless signals.
To Next Page
Loading...
Need help?
General
