Heater Model Nominal Voltage
Heating Capacity
Nominal Defrost Supplemental Standby and Emergency
KW MBH KW MBH KW MBH KW MBH
2HS045010
25A 240
1
10 34.2 10 34.2 10 34.2 10 34.246A 480
2
50A 480
2
2HS045016
25A 240
1
16 54.7 10 34.2 16 54.7 16 54.746A 480
2
50A 480
2
2HS045026
25A 240
1
26 88.8 16 54.7 26 88.8 26 88.846A 480
2
50A 480
2
2HS045036
25A 240
1
36 123.0 16 54.7 26 88.8 36 123.046A 480
2
50A 480
2
1For 208 volts, multiply the MBH and KW values by (208/240)^2 or 0.751.
For 230 volts, multiply the MBH and KW values by (230/240)^2 or 0.918.
2For 460 volts, multiply the MBH and KW values by (460/480)^2 or 0.918.
For 380 volts, multiply the MBH and KW values by (380/480)^2 or 0.627.
For 415 volts, multiply the MBH and KW values by (415/480)^2 or 0.747.
ELECTRIC HEAT ACCESSORY
HEAT PUMP ONLY
HEATING CAPACITIES
Temperature Air
on Indoor Coil,
°
F DB
Temperature of Outdoor Air,
°
F DB
0 10203040506070
MBH
1
KW
3
MBH
1
KW
3
MBH
1
KW
3
MBH
1
KW
3
MBH
1
KW
3
MBH
1
KW
3
MBH
1
KW
3
MBH
1
KW
3
E2FB090/F3EH090 @ 3300 Supply Air CFM
2
- 60 HZ
60 27.8 4.06 43.70 6.19 54.10 6.31 63.10 6.63 75.10 6.88 87.60 7.27 96.70 7.51 109.00 8.00
70 23.9 4.25 45.30 6.56 52.90 6.86 59.30 7.02 73.30 7.59 85.90 7.95 95.80 8.31 107.60 8.60
80 20.1 4.48 45.40 7.19 53.00 7.54 59.90 7.80 71.70 8.09 85.10 8.60 94.60 9.04 105.40 9.35
E1FB120/F3EH120 @ 4000 Supply Air CFM
2
- 60 HZ
60 29.8 5.62 48.8 6.43 67.8 7.24 86.7 8.04
65.2105
.7
8.85 124.7 9.66 143.7 10.46 162.7 11.27
70 27.7 5.74 45.5 6.62 63.3 7.51 81.2 8.39 99.0 9.28 116.9 10.16 134.7 11.05 152.5 11.94
80 26.2 5.82 43.2 6.75 60.1 7.67 77.1 8.60 94.1 9.53 111.0 10.45 128.0 11.38 145.0 12.30
E2FB090/F3EH090 @ 3000 Supply Air CFM
2
- 50 HZ
60 24.1 3.37 34.6 3.99 45.1 4.58 57.8 4.98 70.5 5.41 81.0 6.07 91.5 6.86 102.0 7.65
70 20.8 3.53 30.4 4.16 40.0 4.75 51.8 5.15 63.6 5.58 73.2 6.25 82.8 7.05 92.4 7.84
80 17.5 3.72 26.2 4.35 35.0 4.95 45.8 5.36 56.8 5.79 65.5 6.47 74.3 7.26 83.0 8.06
E1FB120/F3EH120 @ 4000 Supply Air CFM
2
- 50 HZ
60 25.9 4.66 42.5 5.34 59.0 6.01 75.4 6.67 92.0 7.35 108.5 8.02 125.0 8.68 141.5 9.35
70 24.1 4.76 39.6 5.49 55.1 6.23 70.6 6.96 86.1 7.70 101.7 8.43 117.2 9.17 132.7 9.91
80 22.8 4.83 37.6 5.60 52.3 6.37 67.1 7.14 81.9 7.91 96.6 8.67 111.4 9.45 126.2 10.21
Correction Factor
% Nominal Supply Air CFM
80 90 100 110 120
MBH 0.96 0.98 1.00 1.02 1.04
KW 1.030 1.015 1.000 0.985 0.970
Outdoor Unit Size 7-1/2 Ton 10 Ton
Outdoor Fan Motor KW - 60 HZ 0.96 1.03
Outdoor Fan Motor KW - 50 HZ 0.80 0.85
1These ratings are based on an outdoor relative humidity of 72%. They include an allowance for defrost but not for the supply air blower motor heat. Refer to the BLOWER PERFORMANCE
table for the KW rating of the supply air blower motor at the design conditions. Convert this KW rating to MBH using the following equation and add this equivalent heat to the heating capacity.
Blower Motor Heat (MBH) = Blower Motor KW x (3.415 MBH/KW)
Use the following equation to determine the C.O.P. at any operating condition:
C.O.P. = Total MBH (Including Blower Motor Heat)/[Total KW (Including Blower Motor KW) x 3.415]
2Correct the MBH and KW ratings with the following factors for different supply air CFM’s.
3These ratings include the compressor KW and the following KW for the outdoor fan motor(s).
NOTE: Apply these factors to the above ratings before correcting
for the supply air blower heat and power requirements.
Blower motor KW is not included. Refer to the SUPPLY AIR BLOWER PERFORMANCE table for the KW rating of the supply air blower motor at the design conditions and add this power
requirement to the KW rating.
515.41-TG1Y
Unitary Products Group 5
To Next Page
Loading...
