York HIDS006B21S - Page 158

5-28
SM-18001-rev.1
EXTERNAL INPUT/OUTPUT AND FUNCTION SETTING
(48) Forced Thermo-ON Stoppage during Cooling (EC)
ThisfunctionisutilizedtoforceThermo-ONandthenstoptheoperationwhencoolingoperationis
stopped.
Thisiseffectivetopreventabnormalodorbecausetheheatexchangerisrinsedwithdrainwaterto
keep in the clean condition.
(49) Not Prepared (Ed)
(50) Not Prepared (EE)
(51) Not Prepared (EF)...(forDuctedHighStaticType)
(51) Automatic Fan Speed Control (Corresponding to HIGH2)(EF)...(forDuctedMediumStaticand
SlimType)
 Thisfunctionisutilizedtoincreasethemaximumfanspeedto"HIGH2"settingconditionwhenthe
maximumfanspeedremain"HIGH"bydefault.
Thefanspeedsetting(EF)byWiredControllerareshownbelow.
(45) Not Prepared (E9)
(46) Not Prepared (EA)
(47) Fan Operation Control during Cooling Thermo-OFF (Eb)
Thisfunctionisutilizedtopreventdiffusionofodorandhighhumiditybyreducingtheindoorfanspeed
duringcoolingThermo-OFF.
SettingCondition Fan Operation
during
Thermo-OFF
00 Operation at Set Fan Speed
01 LOW
02 SLOW
Function
Selection
EFSetting
WiredControllerSetting
AUTO HIGH2 HIGH MED LOW
00 HIGH-LOW HIGH2 HIGH MED LOW
01 HIGH2-LOW HIGH2 HIGH MED LOW
NOTE:
Thisfunctionisnotavailablewhentheauxiliaryheaterisenabled.Fanspeediseither"HIGH"or
"HIGH2"duringthistime.