102777-YIM-E-0206
Unitary Products Group 43
FIGURE 17 - FIELD INSTALLED DISCONNECT
31"
MAXIMUM
DRILL & BOLT
THROUGH UNIT
SHEET METAL
(4 PLACES)
34"
*
6-1/2"
MINIMUM
MAXIMUM DOOR SWING
OF HEAT SECTION
DOOR WHEN OPEN
UNISTRUT
1-5/8" W x 7/8" H
OR EQUIVALENT
47"
*34 INCHES IS THE MINIMUM LENGTH REQUIRED TO
MOUNT TO THE FOUR POINTS SHOWN. THE RAILS CAN
BE EXTENDED TO MOUNT A TALLER DISCONNECT
SWITCH, BUT THESE FOUR POINTS SHOULD BE USED
TO MOUNTTHE RAILS TO THE UNIT.
®
To Next Page
Loading...
