JOHNSON CONTROLS
29
SECTION 3 – HANDLING, STORAGE, INSTALLATION AND REASSEMBLY
FORM 155.30-ICOM2.EN.UL
ISSUE DATE: 12/21/2018
3
VIBRATION AND ISOLATION DETAILS
Before installing the unit, fit rubber vibration isolators to the unit base as shown in Figure 9 on page 31.
Use liners to adjust the levelness of the unit. For unit dimensions, see Table 8 on page 40.
ITEM DESCRIPTION
1 Nut
2 Washer
3 Foundation Bolt
4 Sole Plate
5 Rubber Vibration Isolator
(DIA 1) Base
(DIA 2) Filling with Mortar
FIGURE 8 - VIBRATION AND ISOLATION DETAILS
LD20193
1
1
6
4
4
5
6
5
2
2
3
3
DIAGRAM 1 DIAGRAM 2
To Next Page
Loading...
