York YMC2 - Printer Connections; Control Center Setup; FIGURE 50 - Breckman Printer; TABLE 17 - Brecknell CP130

JOHNSON CONTROLS
135
SECTION 6 - PRINTING
FORM 160.84-OM1
ISSUE DATE: 9/21/2017
6
Brecknell –
Models: Brecknell CP130
• Dimensions:
5.25″Longx3.75″Widex2.5″High
• Paper: Thermal 57mm (2.25”)
• Type: Dot Matrix
• Purchase: 800-637-0529 (North America)
+44 (0) 845-246-6717 (Europe & ME)
• P/N AWT 05-505788 (printer, cable, 1 roll of paper)
• P/N AWT 05-505594 (power supply)
• P/N AWT 05-505671 (case, 20 rolls of paper)
PRINTER CONNECTIONS
Connect the printer to the Control Center Microboard
as follows. Only one printer can be connected at a time.
TABLE 17 - BRECKNELL CP130
Modify the cable and connect as shown below.
MICROBOARD PRINTER FICTION
J2-4 Pin 3 TX Data to the printer
J2-2 Pin 5 Busy signal from the printer
J2-9 Pin 6 Signal Common
LD17609
FIGURE 50 - BRECKMAN PRINTER
CONTROL CENTER SETUP
Chiller ID
Access Level Required: OPERATOR
Using the COMMS Screen, assign an identification
number to the chiller. This number will appear at the
top of each report.
Printer Setup
Access Level Required: OPERATOR
Using the COMMS Screen, the Control Center must be
configured to transmit data in the same format as the
printer is configured to receive the data. The following
values must be entered.
• Baud Rate - Set to 9600 for Brecknell
19200 for OKIPOS
• Data Bits - 8
• Parity - None
• Stop Bits - 1
Printer Type
Access Level Required: OPERATOR
Using the PRINTER Screen, set the printer type to
Weigh-Tronix.
Automatic Data Logging
Access Level Required: OPERATOR
If automatic data logging is desired, a status report can
be automatically printed at a specified interval begin-
ning at a specified time, using the PRINTER Screen.
The interval is programmable over the range of 1 min-
ute to 1440 minutes in 1 minute increments. The first
print will occur at the programmed START time and
occur at the programmed Output Interval thereafter.
The time remaining until the next print is displayed on
the PRINTER Screen.
• Automatic Printer Logging - Enables and disables
automatic data logging.
• LogStartTime ‑Enterthetimethe rstprintis
desired.
• Output Interval - Enter the desired interval be-
tween prints.