JOHNSON CONTROLS
133
FORM 160.84-OM1
ISSUE DATE: 9/21/2017
6
SECTION 6 - PRINTING
PRINTING OVERVIEW
A printer can be connected to the Control Center’s
Microboard to print the following reports. The screen
from which each report can be generated is listed in
parenthesis.
• Status ‑ Present system parameters (Printer,
Home)
• Setpoints ‑ Present programmed values of all set-
points (Printer, Setpoints)
• Schedule ‑ Present value of programmed daily
schedule (Printer, Schedule)
• Sales Order ‑ Information about SALES ORDER
Screen (Printer, Sales Order)
• History ‑ System parameters at the time of the last
normal stop, last fault while running and last 10
faults, whether running or not (Printer, History)
• Cycling or Safety Shutdown Initiated Print ‑
Snapshot of all system parameters at instant of
shutdown. Automatically occurs if printer is con-
nected at time of shutdown.
• Adaptive Capacity Control (ACC) Surge Map
‑ System conditions at instant all surge points
were mapped. (Compressor Motor Variable Speed
Drive applications; requires SERVICE access lev-
el) (Printer, ACC)
• Trend ‑ Prints a snapshot of the existing TREND
Screen data or prints new data collected after the
TREND PRINT key is pressed.
The printer can be permanently connected to the Con-
trol Center or connected as required to produce a report.
If permanently connected, a DATA LOGGING feature
can produce a status report automatically, beginning at
an Operator selected start time and occurring at an Op-
erator selected interval thereafter.
The following figures are examples of the different
print reports. Solid State Starter application print re-
ports shown. Electro-Mechanical Starter and Variable
Speed Drive reports are similar but print parameters
applicable to those devices.
• Status or History - Figure 53 on page 138
• Setpoints - Figure 54 on page 140
• Schedule - Figure 55 on page 142
• Sales Order - Figure 56 on page 142
• Security Log - Figure 57 on page 144
• Trend - Figure 58 on page 144
• CUSTOM Screen - Figure 59 on page 144
ACCEPTABLE PRINTERS
The following printers can be used. Printers must be
equipped with an RS-232 Serial interface.
• Okidata OKIPOS 441
• Brecknell CP130
The Control Center provides the required formatting
control codes for the printers above when the printer
is selected on the PRINTER Screen. These codes are
transmitted through the serial interface to the printer to
provide a proper print format.
Different printers require different formatting control
codes. Other printers might provide proper operation
when connected to the Control Center. However, the
print format may not be correct or as desired.
To Next Page
Loading...
