JOHNSON CONTROLS
11
SECTION 1 – INSTALLATION
FORM 160.81-NOM1
ISSUE DATE: 10/3/2020
1
If optional shipping skids are used, remove them be-
fore lowering the unit to its mounting position. Rig the
unit to its final location on the floor or mounting pad by
lifting the unit (or shell assembly) with an overhead lift
and lower the unit to its mounting position.
Units shipped dismantled should be as-
sembled under the supervision of a John-
son Controls representative.
FIGURE 1 - UNIT RIGGING
LD07958
Spreader Bars
To Next Page
Loading...
