Note: Put charging dock against the wall and remove obstacles about 1 meter at two sides and about 2
meters forward.
2>. Turn on the Power Switch around the power socket, then the display panel will flash.
(If no command is received, the robot wit turns to sleep mode after 15 seconds.)
Note: A. Please always keep the power switch turning on. If not, it is unable to make the robot wort/ B. If
the power switch is turned off, all the scheduling wit be lost.
Caution: Before charging the robot, please make sure the power switch is turned on, or else the
robot can not be charged.
3>. Charge the robot in either way as shown below:
A. Plug into an outlet.
B. Press HOME to make the robot return to the charging dock for charging itself.
For better extending battery life:
A. Before first use, charge the robot overnight. When charging is finished, the display panel will turn off.
B. In normal use, always store the robot on a charging dock with a base plugged in.
C. If the robot is not used for a long time, turn the power switch off. fully charge the robot and store it in a
cool, dry place.
4>. Auto charging
The robot will automatically return to the charging dock when the battery is low.
2. Starting up/Pause/Sleeping
Sleeping mode: Robot is not working, lights around CLEAN button are off and the power switch is on;
Selected mode: Robot is not working, lights around CLEAN button flash;
Cleaning mode: The robot is working. The lights around the CLEAN button are on.
1>. Starting up
To Next Page
Loading...
