Errors
appearance
Likely Cause Solution
Circling in place
V3s Pro robot’s side wheel is stu
ck
Clean V3s Pro robot’s side wheels of hair and debris.
Push them in and out and confirm that they both turn fr
eely. Start V3s Pro robot in a new location.
Keep
moving back
A cliff sensor is dirty or broken. Inspect and clean the V3s Pro robot’s cliff sensors.
Bump the
obstacle continuo
usly
The bumper is compressed
Briskly tap the V3s Pro robot’s bumper 10-20 times to
dislodge any debris that may be trapped under the bu
mper or loosen the screw of the bumper.
Short working tim
e
The battery storage capacity wea
kens. No charging fully.
Replace the battery.
Recharge the robot.
“Cleaning’ light
is off when chargi
ng
Something like pet hair filled in th
e socket of the charger.
is The robot’s battery not connec
ted
Clean the socket, check the connection between charg
er and battery.
Vacuum dirt, debri
s less
The filter is dirty or wet by water. Clean Filter or change the Filter
Spit out litter The dustbin is full. Empty the dustbin.
The robot will not
clean automaticall
y at a scheduled ti
me.
The setting for Time Scheduling i
sn’t saved. The time Scheduling f
unction is canceled when you re-
start the robot.
The robot is powered OFF.
The robot’s battery is low. The ro
bot’s components are tangled wit
h debris.
Reset Time Scheduling function, remember the final co
nfirmation Power ON the robot.
Keep the robot powered ON and on the Charging Dock
to make sure it has a full battery to work at any time. P
ower OFF the robot, clean the Dustbin, and invert the r
obot.
Clean Side Brushes and the Main Brush.
Product Specifications
To Next Page
Loading...
