ZACO V3s Pro - Scheduling; Cleaning mode

A. Make sure the power switch is on;
B. Press the CLEAN button on the main body or on the remote control to start cleaning.
Note: If robot is in sleeping mode, press the CLEAN button to wake the robot up from sleeping mode.
Then press CLEAN for a second time, the robot starts cleaning automatically.
2>. Pause
Press the CLEAN button on the main body or on the remote control to exchange the robot from cleaning
mode to selected mode.
Note: When the robot is paused, press CLEAN to make a robot re-start cleaning.
3>. Sleeping
To turn the robot into sleeping mode from selected mode:
A. Keep pressing CLEAN on the main body for 3 seconds.
B. Robot will automatically enter sleeping mode if no command is received for 15 seconds.
3. Scheduling
You can schedule to let the robot start cleaning from a certain time.
Note: Remember to set the clock time and schedule once replace the remote control battery. Once the
dock time is set, any schedule you have set will make the robot work on the scheduled time.
Setting the dock time
1. Point the remote control towards the robot (ensure the power switch is on).
2. Press CLOCK and then use directional buttons to set the correct time.
3. Press CLOCK to save the setting. To cancel the schedule. Please turn off the robot. Setting a
schedule
The robot will always work at the scheduled time unless the power switch of the robot is turned off.
1. Point the remote towards the robot.
2. Press PLAN and then use directional buttons to set the schedule.
3. Press PLAN to save the setting. To cancel the schedule, Please turn off the robot.
Note:
When you set the clock time or schedule, the final operation will be confirmed by a beep from the robot: It
no tone received your setting is unsuccessful.
4. Cleaning mode
1>. Auto-cleaning
The robot will clean a room automatically and adjust its cleaning according to the situation.
Note: Press the CLEAN button on the robot or on the remote control to start auto cleaning.
2>. Spot cleaning
A.Press Spot on the remote toward the robot when the robot is working. The robot will circle around and
turn into Auto Clean mode after Spot clean is finished.
B.Press Spot on the remote toward the robot when the robot is in selected mode and the robot will begin
to circle around. The robot will turn into selected mode after Spot Clean is finished.
3>. Edge cleaning
Put the robot near the edge (wall) and press EDGE on the remote control to start edge cleaning. Note:
Edge cleaning will automatically stop when robot could not detect any edges, or you could manually
press CLEAN to stop edge cleaning.
.