Product Maintaining
1. Cleaning side brushes
Clean the side brushes when it gets dirty and replace if it’s damaged.
Note: Before replacing side brushes, check and match “L” “R” marks on both the side brush and bottom of the
robot.
2. Cleaning dustbin and filter
Clean and empty dustbin after each use, steps are as shown in below figures. Note:
After taking out the dustbin, check whether there is foreign matter stuck in the suck passage and clean it.
Clean Filter after 15-30 days’ use. And replace it after use for 6 months at maximum.
Install both Filter and primary filters when they are dry.
Filter and primary filter could be replaced if needed.
3. Cleaning cliff sensors and auto charging pins
Slightly clean the sensor window and auto charging pins with a soft dry cloth.
Note: Charging pints on the charging dock need to clean if dirty.
4. Front-wheel cleanup
When there is foreign matter in the front wheel, it will affect the cleaning performance, please clean it follow the
way below:
(1) Pull the wheel up vertically and clean it. Please note whether the gasket is off.
(2) It should be noted that whether the gasket is installed well after clean the front wheel.
To Next Page
Loading...
