The spinning brushes may flick small granules (dog food, cat litter) here and there, but finally, the robot will
vacuum them all in.
Before replacing side brushes, check and match “L” “R” marks on both the side brush and bottom of the robot.
When you set the dock time or schedule, the final operation will be confirmed by a beep from the robot. If no
tone is received, your setting is unsuccessful.
Empty the dustbin. You could notice the robot vacuum less, even spits out, when the dustbin is full, though
there is no warning beep sound.
For Best Performance
Empty V3s Pro’s dustbin and clean its filter after every use.
The filter could not be washed by water.
Replace the new Filter when you notice the V3s Pro vacuum gets weaker and picks up less than before.
Put charging dock against the wall and remove obstacles about 1 meter at two sides and about 2 meters
forward.
Fully charge the robot’s battery before each cleaning cycle.
Battery Life
To extend V3s Pro’s battery life and keep its cleaning at peak performance:
Charge the robot overnight before first-time use.
If the robot is not used for a long time, please turn off the power switch.
Recharge the robot as soon as possible. Waiting several days to recharge may damage the battery.
Use the robot frequently.
Warning: The product contains electronic parts. DO NOT submerge V3s Pro or spray it with water, clean with a
dry cloth only.
[
To Next Page
Loading...
