Why does my Zanussi Dishwasher programme last too long?
If your Zanussi Dishwasher programme lasts too long, check if the delay start option is set and cancel the delay setting or wait for the end of the countdown. Also, activating options can increase the programme duration.
Why is my Zanussi ZDLN6531 not filling with water and showing i10 or i11?
If your Zanussi Dishwasher is not filling with water and the display shows i10 or i11, make sure the water tap is fully open and not clogged. Check that the water supply pressure is adequate by contacting your local water authority. Also, inspect the inlet hose for any kinks or bends and ensure the filter in the inlet hose is not clogged.
What causes stains and dry water drops on glasses and dishes in my Zanussi ZDLN6531?
If there are stains and dry water drops on glasses and dishes from your Zanussi Dishwasher, the released quantity of rinse aid may not be sufficient. Adjust the rinse aid dosage to a higher level, or the quality of the rinse aid can be the cause.
What to do if my Zanussi Dishwasher has limescale deposits?
If you notice limescale deposits on the tableware, tub, or inside the door of your Zanussi dishwasher, check the salt level and refill if the indicator is on. Ensure the salt container cap is tight. If you have hard tap water, refer to 'The water softener' section. Use salt and set water softener regeneration even with multi-functional tablets. You can also start the Machine Care programme with a descaler designed for dishwashers. If the issue persists, try cleaning the appliance with suitable detergents or consider trying a different detergent, and contact the detergent manufacturer.
What to do if my Zanussi ZDLN6531 Dishwasher has poor drying results?
If your Zanussi Dishwasher is producing poor drying results, try activating the AirDry function to automatically open the door. Ensure that there is enough rinse aid, and if not, fill the rinse aid dispenser or increase the dosage. Consider that the quality of the rinse aid can affect drying. Always use rinse aid, even with multi-tablets. Note that plastic items may require towel drying. Finally, verify that the selected programme includes a drying phase.
Why does my Zanussi ZDLN6531 door open during the wash cycle?
The door of your Zanussi Dishwasher may be opening during the wash cycle because the AirDry function is activated. You can deactivate this function; refer to 'Basic settings'.
What to do if my Zanussi ZDLN6531 has dull tableware?
If your Zanussi Dishwasher is causing dull, discoloured, or chipped tableware, ensure that only dishwasher-safe items are being washed. Load and unload the basket carefully, referring to the basket loading leaflet. Place delicate items in the upper basket. You can also activate the Glass Care option for extra protection of glassware and delicate items.
What to do if my Zanussi Dishwasher has residues of detergent in the dispenser?
If there are residues of detergent in the dispenser of your Zanussi Dishwasher at the end of the programme, the detergent tablet may have been stuck and not washed away. Make sure the spray arms are not blocked or clogged, preventing water from reaching the dispenser. Also, ensure that items in the baskets do not impede the detergent dispenser lid from opening.
How to fix small leak from Zanussi Dishwasher door?
If there is a small leak from the door of your Zanussi Dishwasher, the appliance may not be levelled. Loosen or tighten the adjustable feet to correct this. Also, the door may not be centred on the tub; adjust the rear foot if applicable.
What causes whitish streaks on dishes from my Zanussi ZDLN6531?
Whitish streaks or bluish layers on glasses and dishes from your Zanussi Dishwasher are often due to the released quantity of rinse aid being too high. Adjust the rinse aid dosage to a lower level. Also, the quantity of detergent may be too high.
General| Product size | Full size (60 cm) |
|---|---|
| Control panel colour | Black |
| Number of Place Settings | 13 |
| Noise Level | 44 dB |
| Number of washing programs | 8 |
| Washing class | A |
| Drying class | A |
| Cycle time | 240 min |
| Annual Energy Consumption | 237 kWh |
| Drying Performance | A |
| Cleaning Performance | A |
| Delay Start | Yes |
| Half Load Option | Yes |
| Width | 596 mm |
| Depth | 550 mm |
| Height | 818 mm |
| Appliance placement | Built-in |
| Water consumption per cycle | 9.9 L |
| Annual Water Consumption | 2772 L |
| Programs | Eco, Glass, Intensive, Quick |
| Drying system | AirDry |
To Next Page
