Page - 98/100 AE0ZP0EC - AC-0 SSL SENSORED - User Manual
12.2 MDI-PRC “ALARMS” List
When the Controller communicates with the MDI-PRC, the alarm condition is
represented on the MDI-PRC in a Numeric form is:
Source Device Code and Alarm Code.
The Source Device Code we are interesting in is:
05: This is a Pump Controller (AC-0) alarm
The Alarm Code List Sourced by the Controller (Source Device Code 05) is the
following:
1: WRONG CONFIG
8: WATCH DOG
13: EEPROM KO
16: AUX OUTPUT KO
17: LOGIC FAILURE #3
18: LOGIC FAILURE #2
19: LOGIC FAILURE #1
30: VMN LOW
31: VMN HIGH
37: CONTACTOR CLOSED
38: CONTACTOR OPEN
49: I=0 EVER
53: STBY I HIGH
60: CAPACITOR CHARGE
61: HIGH TEMPERATURE
65: MOTOR TEMPERAT
67: CAN BUS KO
70: ENCODER ERROR
73: THERMIC SENS KO
74: DRIVER SHORTED
75: CONTACTOR DRIVER
76: COIL SHORTED
78: VACC NOT OK
79: INCORRECT START
86: PEDAL WIRE KO
94: CURRENT SENS KO
93: WRONG SET BATT.
99: CHECK UP NEEDED
Example: 05A79 is an INCORRECT START alarm on the AC-0 Pump controller.
To Next Page
Loading...
