125
Routine Maintenance
Cleaning Schedule and Procedures
3/12/09 Xi4 User Guide P1009874-001
7. To reinstall the snap plate, insert the two tabs on the bottom of the snap plate into the two
slots of the media path.
8. Slide the snap plate toward you.
9. Press down on the loops to lock the snap plate into place.
Clean the Cutter
If the cutter is not cutting the labels cleanly or if it jams with labels, clean the cutter.
To clean the cutter, complete these steps:
1. Turn off (O) the printer.
2. Unplug the power cord.
3. Using the swab from the Preventive Maintenance Kit (part number 47362), clean the
stationary cutter blade. In place of the Preventive Maintenance Kit, you may use a clean
swab dipped in a solution of isopropyl alcohol (minimum 90%) and deionized water
(maximum 10%). Allow the solvent to evaporate.
4. If cleaning does not remove label fragments and adhesive, contact an authorized service
technician.
Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.
To Next Page
Loading...