109
Printer Configuration and Adjustment
Adjust Printer Settings
8/25/15 ZT400 Series™ User Guide P1066582-003
Print
Information
(continued)
Accepted values:
• SETTINGS—prints the printer configuration label.
• NETWORK—prints the settings for any print server
that is installed.
• FORMATS—prints the available formats stored in the
printer’s RAM, Flash memory, or optional memory
card.
• IMAGES—prints the available images stored in the
printer’s RAM, Flash memory, or optional memory
card.
• FONTS—prints the available fonts in the printer,
including standard printer fonts plus any optional
fonts. Fonts may be stored in RAM or Flash memory.
• BARCODES—prints the available bar codes in the
printer. Bar codes may be stored in RAM or Flash
memory.
• ALL—prints the previous six labels.
• SENSOR PROFILE—shows the sensor settings
compared to actual sensor readings. To interpret the
results, see Sensor Profile on page 195.
Related ZPL command(s):
SETTINGS:
~WC
NETWORK: ~WL
SENSOR PROFILE: ~JG
Others: ^WD
Control panel key(s):
SETTINGS and NETWORK: Do one of the following:
• Hold CANCEL during printer power-up.
• Hold FEED + CANCEL for 2 seconds when the
printer is in the Ready state.
SENSOR PROFILE: Hold
FEED + CANCEL during
printer power-up.
Printer web page: View and Modify Printer Settings >
Print Listings on Label
LCD Contrast Change the contrast on the printer’s display.
User menu item:
Main Menu >
TOOLS
Accepted values:
3 to 15
SGD command used:
display.contrast
Table 6 • Tools (Continued)
To Next Page
Loading...