Zebra ZT410 - Page 110

Printer Configuration and Adjustment
Adjust Printer Settings
110
P1066582-003 ZT400 Series™ User Guide 8/25/15
Idle Display Select the information shown on the printer’s display when the printer is idle.
User menu item:
Main Menu >
TOOLS
Accepted values:
• FW VERSION
• IP ADDRESS
• MM/DD/YY 24 HR
• MM/DD/YY 12 HR
• DD/MM/YY 24 HR
• DD/MM/YY 12 HR
SGD command used:
device.idle_display_format
Power-Up Action Set the action for the printer to take during the power-up sequence.
User menu item:
Main Menu >
TOOLS
Accepted values:
• CALIBRATE—adjusts sensor levels and thresholds,
determines the label length, and feeds the media to
the next web.
• FEED—feeds the labels to the first registration point.
• LENGTH—determines the label length using current
sensor values, and feeds the media to the next web.
• NO MOTION—tells the printer not to move the
media. You must manually ensure that the web is
positioned correctly, or press feed to position the next
web.
• SHORT CAL—sets the media and web thresholds
without adjusting sensor gain, determines the label
length, and feeds the media to the next web.
Related ZPL command(s):
^MF
SGD command used:
ezpl.power_up_action
Printer web page: View and Modify Printer Settings > Calibration
Table 6 • Tools (Continued)
▼
IDLE DISPLAY
FW VERSION
▲
▼
POWER UP ACTION
CALIBRATE
▲