Zepro ZU 75-110 - Safety Rules; Moving Parts - Free Movement; Connection of Third-Party Equipment is Forbidden; Installation Safety

Z 45/75-90/110
8
Safety rules
www.zepro.com
2 Safety rules
2.1 Moving parts - free movement
m WARNING!
Duringnalinspection*,thespaceoccupiedbythe
moving cylinders must be cleared and made safe.
There is a risk of collision between the cylinder and
the following items: subframe, truck chassis, beam
for rear light (number plate) and the chassis bracket
of the lift (with a short overhang).
**Finalinspectiontobecarriedoutwiththeplatform
atthevehicleoorandtilteddown10°.Theclear-
ance from the closest part of the cylinder must be
at least 40 mm.
m WARNING!
The platform may not be tilted down more than
10º from the horizontal.
min. 40 mm
10º
10º
Image 5. Clearance to the closest
part of the cylinder must be at least 40 mm
Image 6. The platform may not be tilted
down more than 10º from the horizontal
2.2 Connection of third-party equipment is forbidden
m WARNING!
Connecting third-party equipment (electric or hydraulic) to Zepro tail lifts is forbidden. Connecting third-party
equipmentcouldinterferewiththelift’ssystemanditssafetyfunctions.Riskofinjuryanddamage.Ifitis
necessarytoinstallotherequipment,checkthevehiclemanufacturer’sbodyinstructionsandusetheat-
tachment features on the vehicle.
2.3 Installation
m WARNING!
Installation where the platform cannot reach ground level is prohibited.
m WARNING!
ZEPRO tail lifts are only approved for installation using ZEPRO assembly kits.
IMPORTANT!
Allspeciedtighteningtorquesapplywhenusingtorquewrenchorscrew/nutrunnerwithtorquecontrol.
Torque spread max ±5%.