10
1. Once the ZX-10 is fully charged insert your Micro SD Card into the
correct slot (See 4.0 COMPONENTS on page 6).
2. Press the ON/OFF button on the front of the unit to turn ON the
ZX-10.
3. Press and hold the shoot/record button on the top of the unit. This
will bring up the navigation menu. The navigation menu defaults
to open in the video/image/Playback settings (dependent on what
mode your ZX-10 is currently in).
4. Quick press the shoot/record button again once in the navigation
menu to navigate to the settings menu.
5. Press the down button five times on the right side of the unit to
navigate down the menu to ‘Format’.
6. Press the shoot/trigger button again to open the Format section.
7. Press the shoot/trigger button again to click ‘Yes’. This will initiate
the formatting of the Micro SD card.
NOTE:
Formatting the Micro SD card will permanently erase all data stored on
the Micro SD card. Be sure to back up all saved data prior to formatting.
To Next Page
Loading...
