ZERO-X ZX-10 - Setting the Date and Time on ZX-10

12
2. Press and hold the shoot/record button on the top of the unit. This
will bring up the navigation menu.
3. Quick press the shoot/record button again once in the navigation
menu to navigate to the settings menu.
6.4 SETTING THE DATE & TIME
To set the correct date and time on your ZX-10, turn the unit on and
follow the steps below:
1. Press the shoot/record button to end recording if you are in video
mode and recording.
2. Press and hold the shoot/record button on the top of the unit. This
will bring up the navigation menu.
3. Quick press the shoot/record button again once in the navigation
menu to tab over to the settings menu.
4. Press the down button once to navigate down the menu to ‘date/
time’. You will see this option highlight.
5. Quick press the shoot/record button again once to open the date/
time settings. A screen will appear with the date and time.
NOTE: The number which is highlighted yellow can be changed with
the up and down buttons. The date is set as DD/MM/YYYY,
and the time is 24 hour mode and is set as HH:MM.