Starting and Operating
4.2
Unpacking Your Zero Motorcycle
Although unpacking your Zero Motorcycle can be done by
a single person, it is recommended to have a second
person to help lift and remove your motorcycle from the
crate base.
Outer Box Cover
Cut and remove the two outer box retention straps.
Unscrew stabilizer bar bolts, one on each side of outer
box.
Open box top and remove inner cardboard end
reinforcement sleeves.
Unscrew stabilizer bar from handlebar end and remove
(FX/MX only).
Unscrew lower crate cover retaining screws and
washers.
Lift or cut outer box away from motorcycle.
Inner Assembly
Carefully remove plastic cover from motorcycle.
Locate small parts box below motorcycle and put to the
side. (This box contains important documentation,
owner’s manual, keys, etc.).
Remove the power pack rail.
Remove the power pack.
Remove the tie down straps from crate base (MX only).
Carefully lift rear portion of the motorcycle over the
swingarm standoff and off crate base.
Carefully lift front wheel out of crate base.
Deploy kickstand, lean motorcycle and inspect in
accordance with delivery inspection sheet.
Recycling
Your Zero Motorcycles shipping crate and packaging
materials were designed to be completely recycled. Please
cut down and recycle all cardboard, plastic, and metal
materials in appropriate receptacles.
The tie down straps that accompanied your motorcycle
can be reused as regular tie down straps.
Zero Owner's Manual (X, MX and XU).book Page 2 Monday, April 29, 2013 3:30 PM
To Next Page
Loading...
Need help?
General
