General Maintenance
5.12
Brake Pad Inspection
The brake pads must be inspected when specified in the
maintenance schedule. See Maintenance Schedule
information on page 5-2
. Visually inspect the brakes by
looking at the remaining brake pad material through the
sides of the brake caliper.
Replace the brake pads if
either pad’s thickness is 0.05
in (1.35 mm) or less. If the
brake pads (A) are worn,
replace both brake pads
immediately.
The brake rotor should also
be checked for thickness.
The minimum thickness is
0.15 in (3.85 mm).
Suspension
Front
For maintenance, see Maintenance Schedule on
page 5-2
.
To adjust the fork, see Suspension Adjustment on
page 4-16
.
Rear
CAUTION: The shock absorber assembly contains highly
pressurized gas.
Do not attempt to tamper with or open the cylinder or
shock.
Do not subject the shock to high temperature or open
flame.
Doing either of these can cause the cylinder or shock
to explode causing personal injury or death.
For maintenance, see Maintenance Schedule on page 5-2
.
To adjust the fork, see Suspension Adjustment on
page 4-16.
Zero Owner's Manual (X, MX and XU).book Page 12 Monday, April 29, 2013 3:30 PM
To Next Page
Loading...
