Troubleshooting
6.15
General Troubleshooting
SYMPTOM POTENTIAL CAUSE POTENTIAL SOLUTION
Motorcycle does not turn on Power Pack not charged. Key not properly engaged.
Motor stop switch turned OFF. Fault code set.
Charge Power Pack. Recheck key in ignition, turn OFF/ON
again. Press the motor stop Switch ON button. See
Understanding BMS Flash Code Patterns (Charge Mode) on
page 6-4
.
Charger not working A/C power missing Fault code set Check A/C outlet for power, A/C source check fuse/voltage.
See Understanding BMS Flash Code Patterns (Charge Mode)
on page 6-4
.
Handlebars wobbly (shimmy) Incorrect tire pressure Inflate to correct tire pressure. See page 5-13
for additional
information.
Deformed front tire Replace/balance front tire with the same tire supplied from the
factory.
Bald tire (excess wear) Replace/balance tire with the same tire supplied from the
factory.
Loose headset bearings Inspect the headset for wear or damage, replace any worn or
damaged parts. Tighten the headset pre-load.
Zero Owner's Manual (X, MX and XU).book Page 15 Monday, April 29, 2013 3:30 PM
To Next Page
Loading...
Need help?
General
