General Operation
4.11
change the amount of time that the motorcycle takes to
charge.
Note: AVOID connecting the Zero charger and another
device to a single 120 V AC 15A/20A circuit, as it may
become overloaded. Zero chargers draw as much as
10 amps from the 120 V AC circuit when charging.
4. Charging a fully discharged power pack to 100% takes
about:
FX/XU ZF2.8: 4.1 Hours
FX/XU ZF5.7: 7.8 Hours
MX ZF2.8: 2.7 Hours
MX ZF5.7: 4.9 Hours
Quick Charging (Off-board Accessory Charger)
The “scalable” quick charging feature allows up to three
supplemental accessory chargers (in addition to the
existing integrated charger) to be connected to the
motorcycle. Use of supplemental accessory chargers can
reduce the charging time by up to 70%.
Note: The time for charging the motorcycle using quick
charging will vary with the number of chargers used.
The auxiliary/standalone charging connector is located on
the right-side of the motorcycle below the battery pack. For
more information on how to connect additional chargers,
refer to the quick charger’s owner’s manual.
A. AC Power Cord
B. AC Power Cord Connection
C. Power Pack Charger
D. Charger LED Indicators
E. Connector (to motorcycle)
C
E
B
DA
Zero Owner's Manual (X, MX and XU).book Page 11 Monday, April 29, 2013 3:30 PM