Dry air cleaner maintenance instructions
Recovery of the mainair cleaner element
Replacing the safety element of the air cleaner
4. Bleed the injection pump in the same way.
5. Do the bleeding with the screw (3) positioned on the
pump body.
E708
Perform maintenance of the air cleaner in the following
way:
1. Remove the right side plate of the hood
2. Release the clamps of the air cleaner lid (marked with
arrows)
3. Remove the air cleaner lid (1)
G712
Remove the main element of the dry cleaner (2) by
pulling.
If the main element is not damaged (there must not be an
dust on the inner side of the element), recover it by
blowing pressurized air from the inner side of the element.
This way you can recover the main element 3 times at the
most. The element must be replaced once a year.
G713
Remove the safety element of the dry cleaner (3) by
pulling.
The safety element cannot be recovered. It
must always be replaced in these cases.
- If the main element is damaged.
- After covering 2000 hours of work
- At least once every two years.
G714
To Next Page
Loading...
Need help?
General
