Note: The 380/70R24 tyre is a dimensional equivalent of the 13.6R24 tyre.
The 420/70R24 tyre is a dimensional equivalent of the 14.9R24 tyre.
The specified load-bearing capacities of tyres for field work and road transport correspond to the maximum
travelling speed of the tractor, i.e. in the case of radial tyres 40 km/h and in the case of diagonal tyres 30
km/h. The specified val-ues refer to one tyre. For a tractor the max. load per axle must not exceed the max.
load-bearing capacity values of the tyres.
Recommended inflation values of the rear wheel tyres
The value of the permitted load-bearing capacity of the rear axle must not exceed the sum of the load-
bearing capacity values of both the tyres that are installed on the axle. The values of the permitted load-
bearing capacity of the axles are specified in the 'Main technical parameters' of the corresponding tractor
type. On the same axle of the tractor there must not be tyres of different dimensions and designs (in this
case tyre design means the diagonal or radial tyre version).
Note: Inflate the front as well as the rear tyres to the lower of the above mentioned values for field work on
light soil (dry, sandy). The higher of the above mentioned pressure values is designed for work on heavy and
compact soil. During ploughing work at the minimum inflation value there must not be any folding of the side
parts of the tyres. The load-bearing capacities specified in the tables correspond to the maximum travelling
speed of the tractor, i.e. in the case of radial tyres 40 km/h and in the case of diagonal tyres 30 km/h. The
specified values refer to one tyre. For a tractor the max. load per axle must not exceed the max. load-bearing
capacity values of the tyres.
During loading of the tractor the maximum values of the permitted load-bearing capacity of the axles
mentioned in the 'Technical parameters of the tractor' table must not be exceeded. Changes of the load-
bearing capacity of the tyres from the basic values are specified in the tables below.
Note: The 100% inflation values of tyres are specified in the tables of recommended tyre inflation in the part
'Principal working activity - for field work'.
Tyredimensions and design
Principal working
activity
540/65 R24 480/65 R28 14,9R24 420/70R24
For field work Inflation (kPa) 130-160 130-160 130-160 130-170
Load-bearing capacity
(kg)
2410-2725 2150-2430 1490-1700 1665-1900
For road transport Inflation (kPa) 160-190 160-190 130-160 190
Load-bearing capacity
(kg)
2410-2725 2150-2430 1490-1700 1665-1900
For work with a front
loader at the
maximum permitted
speed of 8 km/h.
Inflation (kPa) 200 200 200 200
Load-bearing capacity
(kg)
4105 3680 2500 2300
Tyredimensions and design
Principal
working activity
650/65R38 600/65R38 18,4R38 520/70R38 580/70R38
For field work Inflation
(kPa)
130-160 130-160 130-160 110-160 130-160
Load-
bearing
capacity
(kg)
3620-4125 3200-3650 2625-3000 2635-3350 3475-3880
For road
transport
Inflation
(kPa)
160-190 160-190 130-160 110-160 160-190
Load-
bearing
capacity
(kg)
3620-4125 3200-3650 2625-3000 2635-3350 3475-3880
To Next Page
Loading...
Need help?
General
